RHUB TM-800 Manual do Utilizador descarregar pdf (Página 21)

5. Users authenticated using LDAP integration

Click the Integration “LDAP” link and you will be shown the settings in Figure 5.1. To integrate

with the LDAP server, specify:

• the LDAP server’s IP address as the Host IP address

• the LDAP Port for TCP communication (not the SSL port)

• any user’s distinguished name as the User DN

• the Password for the user specified in the User DN field

Figure 5.1 Enable LDAP integration

Only LDAP Version 3 is supported. No SSL encryption can be used for User DN and Password

authentication. If a user with valid credentials fails to pass authentication by your LDAP server,

check the following:

• Your LDAP configuration meets with the work conditions of this system.

• Your LDAP entries have the "distinguishedName" (DN) attribute filled with proper values.

Empty values are not allowed. A Microsoft Active Directory server should automatically fill

proper values for the attribute.

If the LDAP authentication fails, you have two ways to access your RHUB appliance:

• Disconnect this appliance from your LDAP server in order to force this system to use its

local saved user credentials to continue user authentication.

• Reset this system, which will disable the use of the LDAP service.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Sem comentários

RHUB TM-800 Manual do Utilizador Página 21