RHUB TM-270 Manual do Utilizador descarregar pdf (Página 4)

If the page does not display and you are familiar with your router, check the IP address your

router has assigned to the RHUB appliance, which is named “myonlinemeeting”. Then input the

IP address in your browser’s address bar and you will be able to access the RHUB appliance.

If the page does not display and you are not familiar with your router, go to the following initial

startup method.

II. Local Access

For the TM-600, TM-800, TM-1000, and TS-700 appliances only, if you fail to access the

appliance by the above method, do the following:

 Plug in your keyboard, mouse and monitor to the appliance

 Power on the appliance

 Wait for 1 minute

 Type “turbomeeting” as the Username and “password” as the Password

 Wait for up to a couple of minutes and you will be connected to the Fedora desktop.

 Open a browser by clicking the browser icon on the top banner

 This will take you to the TurboMeeting web login page (Figure 1.2)

 Follow the sections below to configure the appliance using the browser.

Figure 1.2. Login

For the TM-250-E, TM-550, TM-510 and TM-560 appliances only, if you fail to access the

appliance by Plug-and-Play, do the following:

 Plug a serial cable between the appliance and a computer

 Power on the appliance

 Wait for 1 minute

 Use HyperTerminal or the open source TeraTerm program

 Type “admin” as the Username and “password” as the Password

 Type “ifconfig” to determine the IP address (inet addr) of the appliance

 Follow the sections below to configure the appliance using the browser.

III. Direct-Cable Connection

The direct-cable connection method is only used for the TM-200 and TM-260. Before you use this

method, configure your computer (in any operating system) with the following IP setting:

 IP Address: 192.168.1.100

 Subnet Mask: 255.255.255.0

Next, do the following:

1 2 3 4 5 6 7 8 9 ... 32 33

Sem comentários

RHUB TM-270 Manual do Utilizador Página 4